Rainsong Hybrid Carbon Fiber Acoustic - Neck Re-set, New Bone Saddle, Fret Dressing, Setup

A curious case of a fairly new Rainsong that left the factory with a poor neck set.  The bridge and saddle were too low out of the gate so lowering the action at the saddle was not possible; nor was to shave the bridge.

The neck heel is bolted on but the fingerboard was glued to the top using epoxy.  After heating I was able to remove it from the top and correct the angle by removing material from the heel and inserting a shim.  Then, I dyed epoxy black and glued the fingerboard back on while the heel was bolted. 

Finally, I shaped a new bone saddle and did a fret dressing before setting up!